While I was working away on this gun during the weekend, some of you were discussing the different methods that could be used to bring a coin finish back to its original glory, this nice little gun was the victim of owner neglect...he was too busy to properly clean the gun after a cold december shoot and this was the outcome,....it looked like the first rusting treatment on a barrell browning job!
[url="http://www.hunt101.com/?p=510962&c=500&z=1"]
[/url]
[url="http://www.hunt101.com/?p=510963&c=500&z=1"]
[/url]
[url="http://www.hunt101.com/?p=510965&c=500&z=1"]
[/url]
[url="http://www.hunt101.com/?p=510964&c=500&z=1"]
[/url]
After an hour of fitting drivers to very fine screw slots the gun was totally disassembled and the clean up began using a stiff bristle brush and a commercial cleaning paste that removes rust and discoloration,...it has a mild acidic base and will pull rust right out of the engraving without damaging or dulling the cutting which so often happens when people try to do this with the wrong abrasives
[url="http://www.hunt101.com/?p=510969&c=500&z=1"]
[/url]
Washing under the tap with warm water and srubbing with detergent will remove all paste residue and while the steel is still warm I use compressed air to remove all moiture.
[url="http://www.hunt101.com/?p=510971&c=500&z=1"]
[/url]
After all the parts are clean and dry a bit of permanent flat black ink is rubbed in to the engraving to make it stand out a bit and let dry for a few hours...
[url="http://www.hunt101.com/?p=510972&c=500&z=1"]
[/url]
The gun is then oiled and reassembled and these are the results!
[url="http://www.hunt101.com/?p=510973&c=500&z=1"]
[/url]
[url="http://www.hunt101.com/?p=510974&c=500&z=1"]
[/url]
[url="http://www.hunt101.com/?p=510978&c=500&z=1"]
[/url]
[url="http://www.hunt101.com/?p=510975&c=500&z=1"]
[/url]
Good as new!.....I bet you after he gets the bill he won't forget to clean the little 20 anymore
All best,
CJ
Last edited by C. J. Opacak; 08/13/07 03:24 PM.