doublegunshop.com - home Forums General Discussion DoubleGun BBS @ doublegunshop.com Skeleton Butt Plates (Pictures)

Trez:

Thank you for the offer. I might take you up on it in the near future if needed.

I am unsure if our die will shape a unskeleton plate. Once we get a good part and make a model of the working die on a CMM so we can duplicate it, we will try a solid blank and see what happens.

What could possibly go wrong?


Gentlemen:

I believe that once we have this working we will be able to offer custom shaped plates, using the same heel contours of the plate we are trying to make now. A somewhat longer and wider plate should be possible. Custom inside shapes will be possible for sure. I was sent some pictures of butt plates privately that are just gorgeous!

So many vices, so little time. Thanks you all for the help.

Glenn

Glenn,
PM me your address and I'll get one out to you.

Just to add my two cents. I agree on thicker being better. The "neidner" plates offered by Brownells and others are way too thin. I think what you're making is looking real good.

Dave