It is a 1963 gun but it is an inexpensive one designed for 2 1/2" shells. I was hoping to use Universal but that is published at 11,500psi so even if I drop it a half grain with 5/8 oz.shot I doubt it would go below 11K. I think I may have the duster wads on hand but I have had experience with some of the smaller brands like Windjammer and they come out way above the published data. There was a thread the other day about this wad with Clays powder in 12g. published at 5500psi and I did not trust it and had Ambrust check them. They came in over 7500 psi as an average.
The more I learn, it seems, the less I know. A little knowledge can be a dangerous thing. Curious, I have switched to PB for my low pressure 12g. loads for a lot of reasons but in 28 gauge it provides a fairly high pressure load.
Last edited by builder; 12/23/08 12:00 PM.
