Each post has given me a little more information,so for the purpose of clarity:
1. Ensure that the locks are cocked
2. Remove the lever nut (what is the correct name of this part?)
3. Extract the bolt
4. JC wrote- "To remove the right lock you can screw in the removed lever and pull gently on it." I don't understand this step, please clarify.
5. JC wrote - "Then through the hole above the triggers you can tap the left lock out using a q-tip without the cotton or a thin wood dowel."
To replace locks:
1. Small Bore wrote- "........remember to push the triggers forward so they can seat properly before you try to tighten the lock pin up again."
2. Replace the locks and re-install lock bolt and fasten with the lever nut.
With clarification on step 4, is the above correct?
