My old man, rest his bones, was an old time engineer and he used to say "ALWAYS USE THE RIGHT TOOL FOR THE JOB" it was good advice then, and equally good advice now.
Making a proper tool with the correct dia pins is not a difficult task if you have access too, or a friend with a lathe or mill.
Using any other improvised tool that may 'bugger the job up' as we English say, and will prove far more expensive in the long run.
Has anyone priced the cost of having a replacement Firing Pin Disk custom made? No, I didn't think so. I promise you it won't be cheap.
Harry
Last edited by Harry Eales; 07/31/10 02:53 AM.
