Hi:
A chap that I met at the club had the drop increased by refitting the head of the stock to the gun. This was done by the local "gunsmith" and it took about 15 minutes and cost $15.00. The owner waited for the work to be done and told me that all that was done was the angle of the head was changed. This was done by taking very light cuts on the 'cheeks" with a chisel until the drop was correct. The owner was very satisfied!
Since then,I have wondered if others may have changed the drop of a stock via this method! If so, what were the results?
It sounds better than bending a stock!
Comments?
Good shooting,
Leomat
