You might confer with Mike Orlen about putting in soldered choke sleeves of more restriction and then working on them to get the POI and pattern you want. The vertical change might be made by either straightening the barrels (if curved) or a stock bend adjustment. If you go with the stock bending, I'd do that to get the vertical correction first and verify by shooting, then move onto the lateral adjustments in the chokes. But talking it out with Mike or whoever gets the job is needed.
BTW, take a look down your barrels and see if there is any curvature downward of the barrels. I've seen them curved up and down on various guns. It can easily be changed by bending as I recently did this to straighten a set bent by damage.
Last edited by Chuck H; 02/23/07 03:59 PM.
