I do believe this will happen. I believe it enough that I have very nice English walnut blank on the way via ups at this moment from Cecil Fredi. It will go on a Hurst Earle Lefever.
rabbit, you are correct, it is a loose federation. But take a good look at who is involved. Ken Hurst has over 40 years in the business. He has been the Master engraver at 2 of the largest American firearm makers. In addition, he has run their shops for them. I have spoken to Ken on several occasions. I always feel as though I have spoken to some one with a vast knowledge of the firearms business. If any one else had proposed this, I would sit and wait.
The way I see it, this project follows in the traditions of the European Master guild shops. The difference being that modern technology no longer requires them to work under the same roof.
As for changing the design of the gun. I do not believe that is economically feasible.
Pete
