Located several Galazon stock oval's .... Nickel/silver 3/4 X 1 inch.
Gold 5/8 X 15/16 my dilemma is: should the oval be mounted flush with the stock and finish or raised??? It comes with some brads or screws and epoxy.
The oval's I've seen were flush with stock. I just don't know how I can get {four} names engraved on such a small oval.
The gold would look real pretty, considering there is a lot of gold inlaying on the receiver Grade V.
P. S. I did run across a winchester model 42 with solid rib. nice gun but asking way to much for a cost of manufacture 89.00 dollars.
I was at a registered skeet shoot this week end, and all shot over and under's
I just about bet several to shoot my 410 pump gun, see if they could shoot 25 or 14???? I doubt it.....
Last edited by junnie; 09/18/13 03:28 PM.
