Rickyr00,
First things first, how are the bores? What is the wall thickness? Find these things out, very important!!
It appears that the damage is 5" or so from the ends. If the barrels are good, (see above) and are 30" you could simply have them cut to 25" and the muzzles cleaned up. Still a usefull length even though unpopular at the present. Wait a few years and that will change, again! Your chokes will be Cyl/Cyl. That is OK in a upland gun. This will be reasonable cost-wise.
If that is not suitable then I would approach a good micro weld shop. I think that far down the tubes pressure isn't too high. The welding and the proper clean up of the bores and muzzles followed by a proper prep and rust blue should be around 1K.
The wood appears to need dried out, cleaned, refinished and re checkered. No idea what that would cost as I have done this myself in the past for about ten bucks. Acetone, floor dry, your finish of choice.
Your gun now, good luck!
Chief
Last edited by ChiefAmungum; 12/28/13 04:53 PM.
