S |
M |
T |
W |
T |
F |
S |
1
|
2
|
3
|
4
|
5
|
6
|
7
|
8
|
9
|
10
|
11
|
12
|
13
|
14
|
15
|
16
|
17
|
18
|
19
|
20
|
21
|
22
|
23
|
24
|
25
|
26
|
27
|
28
|
29
|
30
|
|
|
|
|
|
|
3 members (dukxdog, azgreg, 1 invisible),
327
guests, and
2
robots. |
Key:
Admin,
Global Mod,
Mod
|
|
Forums10
Topics38,939
Posts550,918
Members14,460
|
Most Online1,344 Apr 29th, 2024
|
|
|
Joined: Aug 2007
Posts: 11,138 Likes: 229
Sidelock
|
Sidelock
Joined: Aug 2007
Posts: 11,138 Likes: 229 |
No worries Dave. Not sure if the end card is still clear as I purchased several cases some time back. But after the info is worn off the cartridges, you can look @ the shot to see about what size is contained therein. If you attend any gatherings where RST is present, you can pick up a few odd boxes and try them.
Another possibility is Gamebore, which has partnered or has been absorbed by Kent(or vice versa) & Gamebore uses that Diamond shot, I believe.
Cheers,
Raimey rse
|
|
|
|
Joined: Jan 2002
Posts: 7,715 Likes: 114
Sidelock
|
Sidelock
Joined: Jan 2002
Posts: 7,715 Likes: 114 |
I know the question is about RSTs, but I wonder why an Elsie with good barrels and a new stock wouldn't be just fine with off the Walmart counter 2 3/4" winchester, federal, or remington shells? Lots cheaper to feed and much greater shell selection...Geo
|
|
|
|
Joined: Dec 2012
Posts: 3,228 Likes: 674
Sidelock
|
Sidelock
Joined: Dec 2012
Posts: 3,228 Likes: 674 |
For grouse I use their 7/8 ounce 7 1/2s followed by the 1-ounce sixes. For pheasants, I would likely use the 1-ounce 6s, followed by the 5s.
Last edited by Lloyd3; 10/19/17 09:01 AM.
|
|
|
|
Joined: Nov 2015
Posts: 52
Sidelock
|
Sidelock
Joined: Nov 2015
Posts: 52 |
In my old Bonehill SXS I use both Polywad and RST. The gun is a 12 ga. I use the Polywad English 2 1/2" 1 oz. Spread-Rs in #6 in the right tube and the RST 2 3/4" 1 1/8 OZ. #5 in the left. I am very happy with the combination and stick with it. I went to Polywad spreaders because RST did not load a spreader with #6. They only went up to #7 and after trying them I was not happy with the killing ability of the #7s. The larger #6 seems to do a much better job. Why not contact Polywad and see if they have the 16 ga. 1 oz. shell in their English line. The English is a 2 1/2" shell.
|
|
|
|
Joined: Jan 2002
Posts: 11,464 Likes: 133
Sidelock
|
Sidelock
Joined: Jan 2002
Posts: 11,464 Likes: 133 |
16 Ga. • 2 1/2" • Paper-Lite • Vel. 1200 • 1 oz. Load - Box
Above would be similar but it doesn't say Roll Crimped?
What are the Copper loads all about?
Cheers,
Raimey rse Raimey, the issue with a lot of copper or nickel shot is that it's just washed on. Doesn't do much to improve the quality of the shot, make it harder, etc. I don't know whether RST's copper shot loads fall into that category. But since I was ordering a flat, including loads for grouse and woodcock as well as pheasants, figured I might as well include a couple boxes. One advantage of copper shot: It's easier to see and remove when you clean the bird.
|
|
|
|
Joined: Feb 2006
Posts: 3,764 Likes: 68
Sidelock
|
Sidelock
Joined: Feb 2006
Posts: 3,764 Likes: 68 |
Dave if the gun was sent to Buck and the chambers were lengthened before, you should have had him glas bed the locks and this way you could be shooting most 16 gauge loads without having to pay a premium. The chambers were changed to 2 3/4" sometime in late 1930 or early 1940 as I have a 1939 that is still 2 9/16". The early 2 3/4" chambered guns had that written on the barrel's water table below the serial number.
I'm not sure when they changed the bore size to .660, but I have a 1927 Specialty that still has .650 bores.
The 16 gauge is my favorite.
David
|
|
|
|
Joined: Jan 2002
Posts: 11,464 Likes: 133
Sidelock
|
Sidelock
Joined: Jan 2002
Posts: 11,464 Likes: 133 |
The Hunter Arms factory drawings included in Brophy's book on LC Smiths show a standard bore diameter of .652 for the 16ga. The drawing is dated April 1938.
|
|
|
|
Joined: Dec 2001
Posts: 1,017 Likes: 70
Sidelock
|
OP
Sidelock
Joined: Dec 2001
Posts: 1,017 Likes: 70 |
David, I failed to mention that Buck did indeed glass bed the action. The gun is fairly light at just under 6 1/2 pounds, so I thought I'd go easy on it with the RST loads. That said, I'd just as soon shoot the 1oz. Herter's and Federal loads I already have in it.
|
|
|
|
|