Your screws are 45 degrees out of time.
Thanks!,
I looked a number of picture and found them in all o'clocks. I found the hinge pin in the wrong way and so on. So I had to decide what looked right.
The hinge pin screw in on the left side and horizontal - that's correct. Right?
The hammer pin screw is notched so it has to go vertical. Right?
The cocker lever pin screw plug that I have vertical should be horizontal. Right?
The hammer pin screw lock screw should be horizontal. Right?
I have several sets of gunsmith screwdrivers - including a set Grace for the Browning A5 that is thiner than most other drivers I have. But the Parker screw slots are even tighter than that. Are there some specific screwdrivers or bits that work well with these small screws?
Is there a trick to working on these small screws? To hold them, I tend to chuck them in my cordless drill chuck.