Thanks Terry!
The Pope Ballard came from our friend Craig. Had to drive to Colorado to buy a gun from a friend from a few miles away!
I will go to the hardware store and grab a 5/16" x 5"-6" bolt and cut the head off it. Then turn down the shank to 1/4" and make a knob to fit the shank. Just need to decide if I go round, door knob shaped, or Schoyen shaped like Neil Rice built. Probably go Schoyen shaped since it has the Schoyen barrel. Like this Rice on my Cody Ballard:

Last edited by Vall; 05/23/18 12:15 PM.