OK. I checked the Parts manual that gives instructions for changing the safety from one hand to the other. First off, There is a part number for a right hand and a part number for the left. Same part numbers for all gauges and all years. Second you have to pull the stock, remove the trigger plate (Bottom screw near the wood end of the receiver) drive out the hammer pin, then the trigger pin. Pull out the old safety and slide in the new one being careful to control the detent and spring. REASSEMBLE IN reverse order. You will have to deal with the hammer spring.
Be sure to use the correct screw drivers. I have seen a ton of buggered screws over the years.
Good luck!
Last edited by Walter C. Snyder; 07/08/18 03:14 AM.
