It does look like they may have come off the ejectors. But, as they are now, if the ejector is back in the cock position, these pins protrude just out of the holes in the ejector box or housing. If the ejectors are ahead in the un-cocked position, they would go ahead far enough that they would be right inside the housing. Is that the correct way? Or should these pins still be just sticking out of the housing when the ejectors are full ahead? If so, then they are too short.
I just had a look at the link that Blue Grouse posted and by looking at the diagram, the pins should be protruding out of the housing when the ejector is back in the cocked position. So these pins are too short.
Last edited by gunsaholic; 02/20/20 04:35 PM.
