Your point is very good. I will measure this very carefully and then decide on a course of action. If too much then I will build back along the edge in some manner. For example I will add a horn spacer to the pistol grip rather than trim the grip cap. If you have any ideas I am open to all suggestions.

Any experience with using veneer? I have walnut +0.064 mm thickness that would raise the level to match the metal and allow for sanding to flush. I have not tried veneer before but might try it. Would be blended in and finished to match the stock color.

Thanks.

Last edited by LetFly; 02/05/21 02:43 PM.