Can someone supply contact info on Mr. Armbrust please? Besides these Kent shells, I have a few other loads I would like tested.
As to Kent's claim of pressures I find it difficult to believe in todays world a large company such as Kent would put out info that was not correct. If an incident were to occur and it was found that their product produced significantly higher pressures then THEY STATE, I would think they would then be in a bit of trouble.
When I asked the person on the phone, he asked me what product number I needed info on. He then looked it up. This means they have pressure info on each product they sell. It is written somewhere where the employee could look it up. I just can't see them leaving themselves liable by stating a certain pressure and it not be legit. I could be wrong.
For those that replied stating they did not believe these numbers because some one else tested them and found much higher pressures, it seems you know some numbers then, so please post the results. It appears that more people than just me care about this topic, so if you have info on it, post it please.
