doublegunshop.com - home Forums General Discussion DIY Gunsmithing @ doublegunshop.com Glue Choice for Stock Repairs

Here's the update:

GFlex Epoxy arrived from Jamestown Distributors.
Applied just enough on both pieces to get a tiny bit of squeeze out (used a trimmed flux brush to apply). Didn't take a picture with the glue, but it's as expected.



Clamped up with strips of bicycle inner tube (c clamp just to keep the ends from unraveling.



I also clamped across the grain because I was having a little trouble getting this front gap to close completely. I started with a regular ratcheting clamp but then ultimately just added another extra right wrap of inner tube.





Left it overnight and took off the bands this morning. there was minimal epoxy on the surface, which I was able to remove with some steel wool.



In the right/wrong light, the crack is visible but I think it will be pretty easy to blend in.