doublegunshop.com - home Forums General Discussion Classic & Custom Single Barreled Sporting Rifles @ doublegunshop.com J P Sauer Tell rifle model V 9,3x57r/360 reloadin

Hello, Im looking for any advice to reload 9,3x57r/360 for this Tellbushe made in 1899 or 1900(by serial number). I allready cut the 9,3x72r cases to 57mm a try them in the gun with 31gr of lovex S062 for 1235fps(not right powder) with Sellier Bellot 193gr collath flat nose soft point. Whats the Best powder for this caliber, load data, max pressure.. Is it 2450 as for 360 express?
Thank you. Martin

True 9,3mm.366 bore (9,1/9,3) is this express rifling? what bullets are safe or the Best to shoot? Bore is wider in the beginning,.375+

9,3mm 193gr semijacket FN SP SELLIER BELLOT,.366 lead 13,2g and type 72U .364 with.375 driving band 14,9g

Um for 250 gr Speer, I think VV N140 for 2200 fps, 2341 bar?? But that may be for 0.358" bullets. So not sure on 0.366"? I would migrate to VV N140 as it noted as being similar to the old R5(Rottweill 5) which was used in the original cartridges.

Serbus,

Raimey
rse

Model V is caliber 9,3x57R/360 E, this gun is registered as 9,3x72r and Last owner shot many these rounds through it. Is still tight.I chronographed sellier bellot 9,3x72r factory ammo - 2192fps =668m/s (max load at reloading table for 9.3x72r) after firing one can clearly see rifling on the case, Last 15mm..Im not sure if was it modified or not, doesnt look Like.

Thank you, so R5 is the same as SM 5?

Is it ok to shoot modern 9,3mm bullet in this rifling? Arent they to hard, that speer 250gr?