Its actually a real eye opener when you have Jon Hosford measure a set of barrels while you are watching and you see the dial move up and down as a set of barrels are measured. Many barrels have a small bit of ripple to them. Actually pretty easy to see with the right light in the right place while you are looking down those barrels at the right angle. As I mentioned I had Jon measure a set of barrels and it certainly seemed at some point in time a dent was raised and then the barrels cleaned up. That thin spot was pretty obvious with Jon's tool with Jon operating it. Reality was it probably wouldn't have caused a problem, but why take a chance. Life is way too short and there are plenty of other guns out there.
Last edited by tut; 04/23/23 04:04 PM.
