doublegunshop.com - home Forums General Discussion Classic & Custom Single Barreled Sporting Rifles @ doublegunshop.com Advice on bullet pullers and recycling components

I recently reloaded some cartridges where I over applied the factory crimp die and distorted the cases to the point they won't chamber. I plan to buy a bullet puller to disassemble the cartridges and recycle what I can. Can anyone recommend a bullet puller they've had good luck with? I'm leaning towards one that I can mount in my press and hopefully remove the bullets without damaging them. These RCBS pullers seem to get good reviews: https://ads.midwayusa.com/product/1012943183?pid=680804 My press is a Lee Classic Cast, so whatever I use will need to fit my press, perhaps using an adapter.

I'm also curious what components can be recycled from the disassembled cartridges? Can the bullets be re-used if they are not damaged? How about the powder and the primed cases? I'm assuming the handful of mis-shaped cases will need to run through a full length sizing die to make them useable again. Like always, I welcome input on these questions.

Thanks!