Two pictuers before I do any thing. 1st one is the "L" shaped ends of the ejector sears. Left barrel one is on the left with blue ink on it. It looks like it is bent inward toward front of the fore end metal see the gap below it and how it is larger than the same opening on the right sear. Now, should I disassemble and bend it back out so the gap is the same on both?
2nd picture shows the top of the sears, the surface that engages the knotch in the ejector hammer. Left barrel one -bad one, is on the left. Its right hand edge is fuller than left hand edge that does the engaging in the knotch. Left side is worn a little bit. Should I make the right egde true with the left side or leave it alone?
