JDW,
I thank you for those data points....but I was looking for data on the 10ga, in one and a quarter ounce loads, short or long. Looking for low stress/dollar practice loads for clays. I have about 30 many fired Remington hulls trimmed down to 2 7/8" and a BAG-O-SP10 wads.......countless Federal huls awaiting as well.
Quite a few of my hulls already went through the BP trial-by-fire, think I only have about 3 burn-throughs though. The rest are pretty roughed up, (BP or not) quite literally as the internal surface of the hulls are quite rough after the first firing?
Any low payload/easy loading suggestions would be greatly appreciated at this point.
Best,
Mark
