Good enough for me Mike- I'll send you both a RH and LH hammer- aprox. 1.25" dim Arc point to c of squared hole- those are .215/.218" nominal- filed them to remove burrs, they are right now "micrometer sticky tight" so there is room for your "final fitting" both hammers are "file hard" I've done a fair amount of TIG welding on tool steels (air, water and oil hdn. grades) and to weld an older unknown grade of steel without first annealing- I'd prefer low temp. brazing if possible-if you are fixing a "shooter" not restoring a museum piece. also advise if you or your pals up in AK need other parts from my "stash" if so, same deal goes for them too.Sorry, could NOT find any hammer screws for you, perhaps Brownells could help?? Best-- RWTF
Last edited by Run With The Fox; 06/09/08 03:28 PM.
