The result of a bad fall:



Tang repaired, stock getting ready for repair for use as a pattern:



fresh off the pantograph:




These fancy back actions are tricky to head up, not much room for error:




I'll post more as this project progresses.

Feel free to PM me with questions or comments to join the discussion.
Steve

An interesting project Steve. Hope the owner didn't participate in the fall and get like damage.

Beautiful replacement wood!

Well Done!!!

Tang holes are drilled "to a point", the Greener FP action is different than most A&D actions in that the female portion of the hand pin is a bind hole, not threaded through the trigger guard boss. A slave pin was turned to mark the location of the blind hole whole while a point was turned on a pin which fit tightly in the top portion of the tang hole.

Slave pin



Blind hole marked




Lining up the points



The full set up



New slave screw for final inletting of the trigger plate



The rear tang screw will be drilled in the same fashion, more pics to follow.

Getting there now.









Wet down with alcohol

Red oil



Diamonds and the recess cut in for checkering in the head.