doublegunshop.com - home Forums General Discussion DIY Gunsmithing @ doublegunshop.com Speaking of Rust Bluing....

Very informative thread, thanks to all that added to it.
As I stated in the General Discussion, I learned mostly from what Dr. Gaddy had posted many years ago and have used his technique. What I haven't read on here was when leaving the barrels in for rusting and then when ready for etching, what do you put in your barrels for protection? For rusting, I use rubber plugs with 1/4" copper tubing bent 90 degrees so the ends are out of the water, for etching I just use rubber plugs. I tried one time using a shellac coat on the inside of the barrels but too much time getting it out. Like Kutter stated, a weep hole is indispensable and most if not all L.C. Smith's have a weep hole near the loop for drainage.
As for bottom ribs not fully soldered, I don't think I have seen one that was soldered fully. I have taken a .001 narrow feeler gage along the bottom ribs and have had it go under the ribs on both sides in a few places. Rust blueing them doesn't hurt anything but when you etch Damascus barrels I always take them out of the solution the bottom rib is facing up when I rinse them under running water. Learned that the hard way.
I hang them to dry and use a propane torch and get it warm to the touch and then spray Kroil oil in the weep hole and hang the breech end up.

Like I stated in the General Discussion, I only do this for myself, no one to answer to except me.

The one thing that I have to say is that I have seen L.C. Smith's refurbished along with refinished barrels and even some of the top notch people doing the work put a high finish on the barrels, From Field Grade to Deluxe they all had a matte finish. So beware of someone selling one that way that states 90% condition as it is not.

bushveld,
Sorry it took so long to get back to you. The rust bluing solution( Streichbruenierbeize) I use doesn't have any of the chemicals listed. The solution is DEWE BRUENOFIX, 8540Rednitzhembach, Industrgebiet, Telefon (09122) 3760 + 4383. The address and telephone number are from 1981, so they may not be current.
Mike

Do you all remove old bluing with a chemical remover (e.g Brownells steel white) or just with the abrasives used for polishing?

Abrasives myself, I polish with the finest grit I can to get the job done efficiently. I use quite a bit of 240 grit Norton emery cloth to remove bluing and find the 1&1/2" wide to be about right for my needs. Good deals on Ebay at times.

Jim,
I don't remove the old bluing with chemical remover prior to polishing but toyed with the idea of using brick cleaner to do it. However, I decided it would save time to clean it with acetone to remove the oil before polishing as oil residue clogs the abrasive cloth. This is in addition to my post polishing acetone cleaning. I am interested others experience, especially if only "spot polishing" might be enough before bluing.
Mike