Hi All
Ok,the stock shows some signs of improvement, I was a bit tentative in my first attempt, the stock is boiling as I write this.
Prior to posting this thread, I saw this video which deals with an attempt to fix stock warp. What AGS wrote makes a bit more
sense to me than the variation used in the video. Thank you once again AGS
Mauser sporter stock warpOk here are some pictures of the stock
![[Linked Image from i.imgur.com]](https://i.imgur.com/v9F3ZAa.jpg)
![[Linked Image from i.imgur.com]](https://i.imgur.com/171ucPC.jpg)
![[Linked Image from i.imgur.com]](https://i.imgur.com/DDHjGzV.jpg)
sorry they aren't better,
here is a picture of my boiling set up, it keeps the forend tip from touching the bottom of the post.
![[Linked Image from i.imgur.com]](https://i.imgur.com/92wBsux.jpg)
And here is a picture of it clamped, the wooden boarded is bolted to the table of my milling machine, the stock is held in place by
bolts going through the triggerguard, and the rubber tubing
![[Linked Image from i.imgur.com]](https://i.imgur.com/JqaLl0R.jpg)