Ken,

Sounds good and I'm another likely owner.

Now, eightbore a few pages back noted that a 10 bore of his acquaintance had 1-1/16" between the firing pins. I am far, very far from my references, but if you are using XX frame dimensions, is one inch between firing pins do-able for a 12 gauge? Much as I may sympathize with the 16 borers (!), I'd prefer a light 12 and 20 gauge combination. I shoot a 6lb 4 oz 12 gauge with 1-1/8th oz. cartridges and 3 dram equivalent so I'd guess the dimensions are the key, rather than weight of the gun.

On other aspects, extractors are fine; the only alternative would be ejectors that can be switched to extractors which may add too much to the cost.

Regards, Tim