If you have a chance at a good deal, but it is running on 440, don't turn it down until you check the data plate on the motor itself. Many can be run on either 220 or 440 and the data plate usually shows wiring diagram for both, if that is the case.
Bushveld,
Good point on the Horizontal mill, you are also likely to get a vertical spindle attachment, a slotting attachment, and maybe a dividing head. My B&S universal no.2 1/2 has a B&S #7 taper in the vertical attachment, which is a little small, but I don't have it wired up anyway.
Mike

Last edited by Der Ami; 09/09/20 07:51 PM.