I need some cast off on this Rizzini br550 but the grain in the wrist scares me. The photos show the 16 yd. pattern plate with a 3 to 4 inch to the left pattern and 3 views of the wrist. The question is should I consider bending for cast off, relieving the cheek area of the stock or a bit of both? We're probably talking about 3/16 to 1/4 of cast or relieve. Any thoughts?
[img]http://[IMG]https://www.jpgbox.com/jpg/62895_600x400.jpg[/img][/img]
[img]http://[IMG]https://www.jpgbox.com/jpg/62896_600x400.jpg[/img][/img]
[img]http://[IMG]https://www.jpgbox.com/jpg/62898_600x400.jpg[/img][/img]
[img]http://[IMG]https://www.jpgbox.com/jpg/62897_600x400.jpg[/img][/img]