I have been doing some experimenting lately with relaying ribs and would welcome some input. I always use four clamps (1/4" aluminum frames with brass screws) for most of the work and add nails with round heads if needed. I have tried (in various combinations) solder no doubt designed for plumbing, lead-free solder, low-temp solder from Brownells (my favorite), and probably some others. Several different fluxes as well but consistency of results is paramount and I have done my best work with a water-based paste flux for plumbing. I had some major frustrations in my latest attempt (an English side by side HG--nothing special) but finally got it right. I would reallylike to hear suggestions. Thanks! Gil
Last edited by gil russell; 11/21/22 12:30 PM. Reason: info added
